Zuchtlichtgrößen und Installationsanleitung
The information below helps configure M&M breeder lights and accessories for your setup. If you need further assistance you can always contact us by email for recommendations.
M&M lights are designed to be used “per individual cage” either as the only light source in your bird room or to supplement existing light in darker cages.
Mounting M&M Breeder Lights
The easiest and most economical way to mount M&M lights is to lay them on top of the cage (top mounting). Use wire ties to secure in place if desired.
If you can’t lay the light on top of the cage use the brackets to hang it on the inside of the cage. The brackets will snap onto the housing or slide on from the end.
Selecting your Breeder Lights and Accessories
M&M lights are powered by a 12 VDC power adapter and many lights can be powered by a single power adapter. They are designed to plug into each other in series, when they are too far apart to plug into each other M&M offers a number of different length DC Extension Cords.
There are 3 sizes of EZ Breeder Lights, each size is addressed below.
24" Breeder Lights
18" Breeder Lights
18” lights are designed for 20" wide to 30" wide cages.
8" Breeder Lights
8" lights are designed for canary cages when the light must be mounted inside the cage and not interfere with the divider panel. They are customarily mounted front to back with the connecting cables running out the back of the cage. Wire cages of this style require two 8" lights per cage mounted in the center of each divided cage half.
Cages with white solid sides, back and top can be lit with a single 8" light mounted just off to the side of the divider. We offer magnetic mounting brackets for cages with solid metal tops.
Examples of using extension cords for stacked cages
Example of 24” and 18” lights
Example of 8” lights